#TWONKY SERVER 7.2 SERIAL HOW TO#

Mm - memory modify (auto-incrementing address) Loady - load binary file over serial line (ymodem mode) Type 'run flash_nfs' to mount root filesystem over NFSīootm - boot application image from memoryīootp - boot image via network using BOOTP/TFTP protocol Net: Internal phy(GE) firmware version: 0x040b NAND: NAND device: Manufacturer ID: 0xec, Chip ID: 0xdc (Samsung NAND 512MiB 3,3V 8-bit)īad block table found at page 262080, version 0x01īad block table found at page 262016, version 0x01 The best idea in case the device is bricked would be to flash u-boot.lq. If the transfer is finished probably you should enter u-boot without an or every password you wish.įrom there it's possible to backup the mtd partitions and flash a new bootloader or whatever someone wants to flash. terminal window where the serial connection is opened.

Now there should something happen on the 2. This will be done from the first console window. Now the bootloader has to be copied on the device. Shortcut R148 on the backside of the pcb and poweron the device.

#TWONKY SERVER 7.2 SERIAL HOW TO#

See here how to connect usb-serial-adapter: #serial I assume that the adapter is '/dev/ttyUSB0'. Open another terminal window and connect to serial console. See serial for how to connect to the device. Connect to the device with an serial adapter, shortcut the 2 pins labeled R148 on the backside of the pcb and power on the device to get UART mode.

Twonky server 7.2 serial